Class SD540
java.lang.Object
edu.wpi.first.wpilibj.MotorSafety
edu.wpi.first.wpilibj.motorcontrol.PWMMotorController
edu.wpi.first.wpilibj.motorcontrol.SD540
- All Implemented Interfaces:
Sendable
,MotorController
,SpeedController
,AutoCloseable
public class SD540 extends PWMMotorController
Mindsensors SD540 Motor Controller.
Note that the SD540 uses the following bounds for PWM values. These values should work reasonably well for most controllers, but if users experience issues such as asymmetric behavior around the deadband or inability to saturate the controller in either direction, calibration is recommended. The calibration procedure can be found in the SD540 User Manual available from Mindsensors.
- 2.05ms = full "forward"
- 1.55ms = the "high end" of the deadband range
- 1.50ms = center of the deadband range (off)
- 1.44ms = the "low end" of the deadband range
- 0.94ms = full "reverse"
-
Field Summary
-
Constructor Summary
Constructors Constructor Description SD540(int channel)
Constructor. -
Method Summary
Methods inherited from class edu.wpi.first.wpilibj.motorcontrol.PWMMotorController
close, disable, enableDeadbandElimination, get, getChannel, getDescription, getInverted, getPwmHandle, initSendable, set, setInverted, stopMotor
Methods inherited from class edu.wpi.first.wpilibj.MotorSafety
check, checkMotors, feed, getExpiration, isAlive, isSafetyEnabled, setExpiration, setSafetyEnabled
-
Constructor Details
-
SD540
Constructor.- Parameters:
channel
- The PWM channel that the SD540 is attached to. 0-9 are on-board, 10-19 are on the MXP port
-